Brushed stainless steel refers to a stainless steel surface like a silky texture, this is only a stainless steel processing process. The surface is matte, look closely on it with a touch of texture, but can not touch. Then the general bright face of stainless steel wear, look more graded. The drawing process will lose the thickness of the stainless steel substrate to a certain extent, usually from 0.1 to 0.2mm. In addition, because the human body, especially the palm of the hand has a relatively exuberant oil and sweat secretion, stainless steel hand often touch with the hand will not leave a more obvious fingerprint, the use of little scratches cannot be seen. Stainless steel wire is a relatively common conventional process on the market, that is, a straight line covered with the entire stainless steel surface is sanded out of the effect, relatively simple, low cost, durable, and fast. Mirror stainless steel production principle, is stainless steel raw materials with grinding fluid through polishing equipment, through more than 8 sets of machines, first coarse sand, and then eliminate grinding head flowers and a series of operations to complete mirror effect, relatively speaking, the mirror effect is much more complex, much higher cost, and the quality of the current market is not the same. Polishing on the substrate, so that the plate surface is flat and the luminosity is as clear as a mirror, the mirror effect looks beautiful, high-end, the disadvantage is easy to scratch, high repair cost. Stainless steel mirror panel products are widely used in building decoration, elevator decoration, industrial decoration, facilities decoration, and other decoration works.
Pros And Cons Of Stainless Steel Surface Treatment (Satin And Polish)
Send Inquiry
