Next, after we screwed in the first screw, we rotated the barn door slider's hanging rail and tracked the position of the second hole. Now is a good time to check if your lifting rails are level. After confirming, drill a hole at the other end of the hanging rail, and then fix the second end with the square head screw like the first one. Don't forget the second end point.
Use a flat rail gasket to drill the remaining holes between the rail and the plate. After drilling, install the remaining square head screws. Then, tighten all screws. Your track is now installed!
Step 4: Cut the bottom of the door into a groove
The door will slide along the upper track by means of a "floor guide" mounted on the floor. The guide requires a 3 / 8-inch wide and 1 / 2-inch deep groove cut in the center of the bottom of the door.
Step 5: Install the barn door slider
We put the barn door slider in the right place, close to the door, mark the points, and then drill the holes. To avoid damaging the wood, we drilled one side until the tip of the shovel pierced the bottom of the door. Then we turned the door over and drilled four holes from that side.
Step 6: Fix the door on the hanging rail
After bolting the hanger to the door, we just need to hook the hanger to the rail to hang it.
Step 7: Install the floor guide block
It's time to install the floor guide block of the barn door slider in place.


