The sliding rails and accessories of the stainless steel barn door hardware should to be installed in the specified position. The fixed screws should be fully installed and straight, in order to ensure the correct use of the accessories after installation. The installation position of the indoor door is installed on the roller slide rails to ensure the installation quality of the stainless steel barn door hardware, so that the barn door runs smoothly.
The sliding rails of the barn door should be vertically balanced on the ground. The main pipe clamp is installed on the plane. The pipe clamp is mainly used to fix the wall and the track. It can be said that it almost supports the weight of the entire barn door, so the pipe clamp The position is very important, and the brick is used as the wall. The position where the two bricks are connected is cracked. Once the pipe clamp is fixed to this position, it is easy to cause instability, which is equivalent to the loss of one pipe clamp support weight. The position of the clips is far apart and there is a possibility that the tube cannot be deformed due to the weight of the load-bearing door. When installing other hardware accessories, install the roller on the door first, and then hang the door on the rail.
If the shaft is on the roller, make sure that the roller is installed on the rail. After installing the door, the swaying device can be installed to ensure that the position of the swaying device is not deviated. After the adjustment, the stopper can be adjusted. In short, different types of rollers and slide rails need to pay attention to all the details during the installation process. Ensure smooth sliding of the stainless steel barn door hardware.

