Email:info@doorroller.com |Quality is our life; Service is ourself.

Pull handles
Current location: Home»Huajian News » News » Latest Events » Ways to deal with the situation that roller doors squeak so much

Recommended Products

Rolling barn door hardware
Rolling barn door hardware
01a
Sliding barn door roller fittings
Sliding barn door roller fittings
1. Using for thickness: 8-12mm glass, suitable for D19/25mm tube. (Bearing the max weight 80kg, DIA70mm, DIA55mm, DIA44mm.)
2. Materia: AISI 304 or AISI 316 stainless steel to select.
3. Surface treatment: Satin or mirror (polished finished).
Sliding interior barn door hardware
Sliding interior barn door hardware
1. Using for thickness: 8-12mm glass, suitable for D19/25mm tube. (Bearing the max weight 80kg, DIA70mm, DIA55mm, DIA44mm.)
2. Materia: AISI 304 or AISI 316 stainless steel to select.
3. Surface treatment: Satin or mirror (polished finished).
Barn door hangers
Barn door hangers
1. Using for thickness: 8-12mm glass, suitable for D19/25mm tube. (Bearing the max weight 80kg, DIA70mm, DIA55mm, DIA44mm.)
2. Materia: AISI 304 or AISI 316 stainless steel to select.
3. Surface treatment: Satin or mirror (polished finished).

Top articles

Latest articles

Your browsing history

    Loading...

Ways to deal with the situation that roller doors squeak so much

Categories: Latest EventsStars: 3Stars Visit: - Release time: 2017-06-21 11:49:00
Font size:【 Large Middle Small Source: Editor: Author:

 

Ways to deal with the situation that roller doors squeak so much

There are a few places you should oil.
1.The end bearing plates supporting the rod have bearings. Oil these by spraying and hoping the oil seeps in.
2.The spring coils. Spray these so the coils don't rub loudly against themselves.
3.All 15 or so hinges on a normal 16x7 door.
4.The vertical wood or weather stripping if either are rubbing.
5.The openers chain if it has a chain.
I use tri-flow bicycle chain oil for steps 1-5 above.

Sometimes the plastic spacer holding the springs away from the center bracket squeaks horribly. That is hard to oil. Only bother to do this if the door is still squeaking.

Now if you have a screw drive opener make sure you use lubriplate low temperature grease for that. It should be greased once a year.

Now with the door down disconnect the opener and lift the door half way. Will the door remain there or will it close or open fully if let go? If it doesn't stay open half way then you need to adjust the torsion springs. The door will often make lots of noise if not properly balanced.

Finally many garage door companies will tell you if you replace the rollers in the door it will make the door quiet. I personally have never noticed this to be true unless the old rollers were defective. Which is very rare.

Information about ""